view service/arduinoNode/readme @ 651:2baf1f0994e3

build and release config Ignore-this: a1a0231a2811ac29f906ca72d85a8c34
author drewp@bigasterisk.com
date Wed, 25 Sep 2019 17:28:38 -0700
parents 49c1756b2edb
children
line wrap: on
line source

node config file:

  board:b0 :device "/dev/serial/by-id/usb-FTDI_FT232R_USB_UART_A900cepU-if00-port0";
    :boardTag "diecimila";
    :connectedTo sensor:motion0 .
    
  sensor:motion0 a :MotionSensor;
    :pin board0:pin3
    :sees :downhallway .

  output:out0 a :GeneralOutput ;
    :pin board0:pin3; 
    :controls :heater .

  output:out1 a :ShiftBrite;
    :shiftbriteL board0:pin5;
    :shiftbriteD board0:pin11;
    :shiftbriteC board0:pin12 .

  output:out2 a :IrEmitter;
    :pin board0:pin4
    .
    
  output:out3 a :RgbStrip;
    :ledCount 10
    .

  output:out4 a :OneWireBus;
    :pin board0:pin5
    :connectedTo sensor:temp0, sensor:temp1 .

  sensor:temp0 a :TemperatureSensor;
    :oneWireAddress "12:14:35:23";
    :feels :downhallway;
    :location house:wall31;
    :height "80cm"
    :pollPeriod "60sec"
    .

  sensor:ir1 a :PowerMeterMonitor;
    :reads :housePower;
    .
    

linux side host:
  read config. we may have any number of arduinos.
  serve the complete arduino code to run.
  poll inputs.
  serve outputs.
  upon request, build arduino code and deploy it.

emits this graph:
    board:b0 a :connectedBoard;
      :host :bang;
      :lastSeen "-1sec" .
    sensor:motion0
      :sees :downhallway;
      :motionState :noMotion;
      :lastRead "16:30:00";
      :lastMotion "16:02:00" .
    sensor:theaterIrDetect
      :sawCode "0e55cc" .
    sensor:ir1 a :PowerMeterMonitor;
      :currentWatts 462;
      :lastPulseTime "16:09:00";
      :kwhPerBlink 1.0;