view service/arduinoNode/readme @ 334:bb80182195c0

arduinonode reads config from etcd. use pushConfig.py to inform all nodes Ignore-this: 3155d873bb30ca82b48ace7531a550e5
author drewp@bigasterisk.com
date Sat, 03 Mar 2018 17:53:37 -0800
parents 49c1756b2edb
children
line wrap: on
line source

node config file:

  board:b0 :device "/dev/serial/by-id/usb-FTDI_FT232R_USB_UART_A900cepU-if00-port0";
    :boardTag "diecimila";
    :connectedTo sensor:motion0 .
    
  sensor:motion0 a :MotionSensor;
    :pin board0:pin3
    :sees :downhallway .

  output:out0 a :GeneralOutput ;
    :pin board0:pin3; 
    :controls :heater .

  output:out1 a :ShiftBrite;
    :shiftbriteL board0:pin5;
    :shiftbriteD board0:pin11;
    :shiftbriteC board0:pin12 .

  output:out2 a :IrEmitter;
    :pin board0:pin4
    .
    
  output:out3 a :RgbStrip;
    :ledCount 10
    .

  output:out4 a :OneWireBus;
    :pin board0:pin5
    :connectedTo sensor:temp0, sensor:temp1 .

  sensor:temp0 a :TemperatureSensor;
    :oneWireAddress "12:14:35:23";
    :feels :downhallway;
    :location house:wall31;
    :height "80cm"
    :pollPeriod "60sec"
    .

  sensor:ir1 a :PowerMeterMonitor;
    :reads :housePower;
    .
    

linux side host:
  read config. we may have any number of arduinos.
  serve the complete arduino code to run.
  poll inputs.
  serve outputs.
  upon request, build arduino code and deploy it.

emits this graph:
    board:b0 a :connectedBoard;
      :host :bang;
      :lastSeen "-1sec" .
    sensor:motion0
      :sees :downhallway;
      :motionState :noMotion;
      :lastRead "16:30:00";
      :lastMotion "16:02:00" .
    sensor:theaterIrDetect
      :sawCode "0e55cc" .
    sensor:ir1 a :PowerMeterMonitor;
      :currentWatts 462;
      :lastPulseTime "16:09:00";
      :kwhPerBlink 1.0;