@prefix rdfs:     <http://www.w3.org/2000/01/rdf-schema#> .
@prefix :         <http://projects.bigasterisk.com/room/> .
@prefix ha:       <http://bigasterisk.com/homeauto/> .
@prefix sensor:   <http://bigasterisk.com/homeauto/sensor/> .
@prefix houseLoc: <http://bigasterisk.com/homeauto/houseLoc/> .


@prefix shopPin: <http://bigasterisk.com/homeauto/boardShop/pin/> .
@prefix shopBarcode: <http://bigasterisk.com/homeauto/boardShop/barcode/> .
@prefix shopButtons: <http://bigasterisk.com/homeauto/boardShop/buttons/> .
@prefix shopOw: <http://bigasterisk.com/homeauto/boardShop/oneWire/> .
@prefix shopShift: <http://bigasterisk.com/homeauto/boardShop/shift/> .
@prefix shopPwm: <http://bigasterisk.com/homeauto/boardShop/pwm/> .

ha:boardShop a :ArduinoBoard;
  :device "/dev/serial/by-id/usb-FTDI_FT232R_USB_UART_A4001hrf-if00-port0";
  :boardTag "atmega168";
  rdfs:comment "board is like diecimila with atmega168";
  :hasPin
    shopPin:d0, shopPin:d1, shopPin:d2, shopPin:d3, shopPin:d4, shopPin:d5, shopPin:d6, shopPin:d7, shopPin:d8, shopPin:d9, shopPin:d10, shopPin:d11, shopPin:d12, shopPin:d13, shopPin:a4, shopPin:a5 .

shopPin:d0 :pinNumber 0 .
shopPin:d1 :pinNumber 1 .
shopPin:d2 :pinNumber 2; :connectedTo shopBarcode:Txblack .
shopPin:d3 :pinNumber 3; :connectedTo shopBarcode:RxGreen .
shopPin:d4 :pinNumber 4; :connectedTo shopOw: .
shopPin:d5 :pinNumber 5; :connectedTo shopButtons:x .
shopPin:d6 :pinNumber 6; :connectedTo shopButtons:x .
shopPin:d7 :pinNumber 7; :connectedTo shopButtons:x .
shopPin:d8 :pinNumber 8; :connectedTo shopButtons:rot .
shopPin:d9 :pinNumber 9; :connectedTo shopButtons:rot .
shopPin:d10 :pinNumber 10; :connectedTo shopShift:data .
shopPin:d11 :pinNumber 11; :connectedTo shopShift:briteLatch .
shopPin:d12 :pinNumber 12; :connectedTo shopShift:lightClock .
shopPin:d13 :pinNumber 13; :connectedTo shopShift:briteClock .

# shiftbrite EI (arduino d12) still needs to be connected to +5

#barcode red: +5V
#barcode white: gnd
#SoftwareSerial barcode =  SoftwareSerial(/* rx pin, green */ 3, 
#                                         /* tx pin, black */ 2,
#                                         /* inverse */ true);